T3 Topway SZP (Single Zone Set)

Based on the tried and tested Emmeti Topway Type 2 manifold, the Single Loop Manifold offers the same feature-rich solution to underfloor heating in a compact single way manifold for use in single zone applications.

Typically, the manifold would be used for adding an underfloor heating circuit in a conservatory or extension either to an existing high temperature radiator system or as an independent circuit from the heat source.

It is designed to allow the connection of an underfloor heating circuit with individual time and/or temperature control of the circuit. Using an Emmeti T3 Control Set with the SLM Single Loop Manifold will allow the primary flow and return temperature to be controlled to a temperature suitable for underfloor heating if a low temperature heat source is not being used. A specially designed T3 control set incorporating an integrated electrothermic actuator has been developed for single zone applications allowing the boiler and pump to be switched on without the additional cost and complexity of an underfloor heating wiring centre.

The SLM manifold is equipped with an electrothermic valve body for use with Emmeti standard electrothermic heads which permit electrical control of the circuit either by a programmable or standard thermostat. Used with a four-wire electrothermic head which includes an auxiliary switch, this also allows electrical interlock with the boiler and pump as required by the Building Regulations. Emmeti’s range of zone controls are designed to complement the operation of the manifold and provide a complete solution for single zone applications

The SLM manifold is pre-assembled and supplied with two offset mounting brackets spaced at 210mm centres, Techno-Varia automatic air vents  and end caps supplied for fitting to each manifold rail and a flow meter fitted to the upper rail which allows both flow adjustment and manual on-off isolation without affecting the flow setting.

Key Features

• Designed to be used with our T3 Control Set range
• Nickel plated extruded brass manifold pre-assembled for use with single zone underfloor heating applications such as conservatories and extensions
• Available in 1” size, with one flow and return connection complete with  automatic air vents, drain and fill valves and end caps
• Can be surface mounted , concealed in a choice of purpose designed plastic or metal cabinets or within a partition wall for a flexible solution to  location
• Manifold flow and return outlets are offset on a double bracket for space saving and ease of installation
• For Ball valves, fittings and Monoblocco pipe connectors for a wide range of pipe types and sizes see ‘Associated Products’ tab
• For Electrothermic actuator and matching zone controls to meet or exceed Building Regulations requirements see ‘Associated Products’ tab